![]() Make sure the panel clips onto the dryer first. Secure it in position with the screws you removed earlier. Once the front plate is secure, reconnect the control panel wire harnesses and place the control panel in position. You can then put the lint filter/ trap back into your dryer. Start by placing the front plate onto the dryer and secure it in place with the screws you removed earlier. Now that the heating element has been successfully installed, you’ll need to put your dryer back together again. Once secured in place, reconnect the wire connectors back up to the element. You can then secure it in place with the screw you removed earlier or, if your new heating element has a screw, use the new one instead. Take the new heating element out of the packaging and place it into position in your Samsung dryer. Don’t worry if you don’t have a multimeter, but if the thermostat is defective you’ll need to replace it. If you have a multimeter, you should test the thermostat to ensure it has continuity. The first task for installing the new heating element into your Samsung dryer is to attach the thermostat to the new element using the four screws you removed earlier. Step 7 – Connect the thermostat to the new element Once the element has been removed, disconnect the thermostat from the element by unthreading the four screws that hold it in place. Make sure you keep the screw in a safe place as you can use it for the new one. This can be done by unthreading the screw that holds it in place and then taking out the element. Once the heating terminals have been disconnected your next task is to remove the heating element. You don’t need to worry about remembering where each one attaches to the heating element as they are all slightly different shapes. Locate the heating element and disconnect the power terminals from it. The front panel should now be able to be removed and you’ll have access to the heating element. Place the filter to one side and keep the two screws in a safe place. Underneath the filter/ trap are a couple of screws that need to be removed. To remove the front cover, open the dryer door and take out the lint filter/trap. ![]() Once disconnected, place the control panel out of the way and put the screws in a safe place. ![]() Be careful not to pull it off completely as you’ll need to disconnect the wire harnesses that connect the panel to the dryer before it can be removed. This can be done by unthreading the screws that hold it in place and then it should clip off. The next step is to remove the control panel from your dryer. Once removed, put it out of the way and keep the screws in a safe place. To remove the cover, unthread the screws that hold it in place and the panel should clip off. This is because the heating element is behind it. Once the dyer has been disconnected from the vent and power supply the next step is to remove the back cover. Next, switch the power off by unplugging your dryer. If your dryer has an exhaust hose attached to it, disconnect it. Start by pulling your dryer out from the wall or, if it is attached to the wall, take it down so you can gain access to the heating element. This guide covers all major Samsung dryer models, including:ĭV48H7400EW/A2-0000 Step 1 – Disconnect your dryer Just make sure you order the correct replacement part from your hardware store or online retailer. All you’ll need is a screwdriver and a replacement element and you should be fine. Simply follow the steps in this guide to remove the old element and install the new one and you’ll have your dryer back operating in no time. But don’t stress, replacing the heating element in your Samsung dryer is easy to do and doesn’t take too long. When this happens, it will need to be replaced. If your Samsung dryer has stopped heating or is not heating properly, a faulty heating element is the most likely cause.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |